Re: DashBox GEM Configuration Manual
Posted: Wed Dec 06, 2017 2:26 pm
Nice doc. One note, you show connecting to com2 as default when using cable (com1 only when xbee module is installed).
But on page 26 it says:
you might want to add 'depending which com port you connected the STS cable to do xyz' some folks will follow guide literally...
for example in my system i use the STS cable on com2 for the dashbox and set it to bin48-net time and on com1 have protocol 2 to send to nodelink...
But on page 26 it says:
Code: Select all
For RS-232 Serial Communication
1. Select the “Packet Send” menu
2. Set “Primary (Com1) Packet Format” to “4 Bin48-NET-Time”
3. Set the “Packet Send Interval” to 5 seconds
4. Set the “Secondary (Com2) Packet Format” to disable
5. Click “Save
for example in my system i use the STS cable on com2 for the dashbox and set it to bin48-net time and on com1 have protocol 2 to send to nodelink...