Upgrading to COM 2.35 forward - Password issues
Posted: Mon Sep 16, 2013 11:15 am
A note here if you're upgrading from a version lesser than 2.35 and you get stuck on the password page.
The password page will always pop-up. The default password is nothing, you should be able to get just by hitting the button.
If blank doesn't work, you'll have to do the following procedure:
- Press the recessed PB switch at the bottom of the GEM and maintain it until the “SYS” LED turns yellow then release.
- The LED will flash “red” three times, then “green” three times, then “yellow” three times, press and release the switch when it flashes "yellow".
Ben
The password page will always pop-up. The default password is nothing, you should be able to get just by hitting the button.
If blank doesn't work, you'll have to do the following procedure:
- Press the recessed PB switch at the bottom of the GEM and maintain it until the “SYS” LED turns yellow then release.
- The LED will flash “red” three times, then “green” three times, then “yellow” three times, press and release the switch when it flashes "yellow".
Ben