Upgrading to COM 2.35 forward - Password issues

Discuss anything which doesn't fall into the other categories here.
Locked
ben
Site Admin
Posts: 4254
Joined: Fri Jun 04, 2010 9:39 am

Upgrading to COM 2.35 forward - Password issues

Post by ben » Mon Sep 16, 2013 11:15 am

A note here if you're upgrading from a version lesser than 2.35 and you get stuck on the password page.

The password page will always pop-up. The default password is nothing, you should be able to get just by hitting the button.

If blank doesn't work, you'll have to do the following procedure:

- Press the recessed PB switch at the bottom of the GEM and maintain it until the “SYS” LED turns yellow then release.
- The LED will flash “red” three times, then “green” three times, then “yellow” three times, press and release the switch when it flashes "yellow".

Ben
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Locked