Getting Started
Posted: Thu Apr 25, 2013 10:49 pm
Ok, so I got my Greeneye monitor, and am getting an electrician to open up the panel tomorrow to connect all the CT's. I have a couple questions though starting with the beginning, and how I configure what I've got.
First, I've been connecting to the web page on the controller using a DHCP address. The first thing I notice is that the page doesn't show properly all the time, and I often need to hit refresh in the browser to show the page correctly.
Next, I tried to set an IP address, and when I click "save", it seems the address is just ignored.
The next thing I noticed so far is that while I downloaded and installed the GEM Network utility, but when I try to launch it on my windows 7 computer, I get the error Run-time error 13. Type mismatch.
Any suggestions on these?
First, I've been connecting to the web page on the controller using a DHCP address. The first thing I notice is that the page doesn't show properly all the time, and I often need to hit refresh in the browser to show the page correctly.
Next, I tried to set an IP address, and when I click "save", it seems the address is just ignored.
The next thing I noticed so far is that while I downloaded and installed the GEM Network utility, but when I try to launch it on my windows 7 computer, I get the error Run-time error 13. Type mismatch.
Any suggestions on these?