Dialing in CT
-
- Posts: 13
- Joined: Sun Apr 09, 2023 12:06 am
Dialing in CT
Just quick clarification, I'm using a third party SolarEdge CT, the Split 200 I purchased from Brultech was too large and didn't fit my panel. I read Teken's post https://www.brultech.com/community/view ... ate#p10506 about calibrating with resistive loads. When he's mentioning fine tuning, is he referring to incrementing the CT Type number (from say 144 for Split-200 to higher / lower numbers) until it matches what I'm measuring with a true RMS DMM. Also I'm unclear on the 2/3/4 CT Range , in what scenario would that be modified.
-
- Site Admin
- Posts: 4262
- Joined: Fri Jun 04, 2010 9:39 am
Re: Dialing in CT
CT Type will increase the reading for each increment (up-to 255, over 255 drop the range by 1).tiredinva wrote: ↑Mon Jun 12, 2023 10:51 pmJust quick clarification, I'm using a third party SolarEdge CT, the Split 200 I purchased from Brultech was too large and didn't fit my panel. I read Teken's post https://www.brultech.com/community/view ... ate#p10506 about calibrating with resistive loads. When he's mentioning fine tuning, is he referring to incrementing the CT Type number (from say 144 for Split-200 to higher / lower numbers) until it matches what I'm measuring with a true RMS DMM. Also I'm unclear on the 2/3/4 CT Range , in what scenario would that be modified.
CT Range halves the value for each increment.
I would start with the Split-200 settings and go from there.
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Brultech Research Inc.
E: ben(at)brultech.com
-
- Posts: 4
- Joined: Mon Mar 13, 2023 8:21 pm
Re: Dialing in CT
Ben,
I have been hoping the micro 100 donuts would come back in stock as I have an 80a circuit that needs the larger thru hole. Any idea if these might be available again, and if not do you have any suggestions on a possible substitute?
I need 2 in case you have some hiding in a corner somewhere you could sell me.
Brian
I have been hoping the micro 100 donuts would come back in stock as I have an 80a circuit that needs the larger thru hole. Any idea if these might be available again, and if not do you have any suggestions on a possible substitute?
I need 2 in case you have some hiding in a corner somewhere you could sell me.
Brian
-
- Site Admin
- Posts: 4262
- Joined: Fri Jun 04, 2010 9:39 am
Re: Dialing in CT
We've cut down on the low-demand CTs so the Micro-100s are discontinued but send sales(at)brultech.com an email. Paul can probably find a couple around.EFIUnlimited wrote: ↑Thu Jul 20, 2023 10:48 pmBen,
I have been hoping the micro 100 donuts would come back in stock as I have an 80a circuit that needs the larger thru hole. Any idea if these might be available again, and if not do you have any suggestions on a possible substitute?
I need 2 in case you have some hiding in a corner somewhere you could sell me.
Brian
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Brultech Research Inc.
E: ben(at)brultech.com