I tried to do a custom date range on the Overview -> Summary page and the total consumption doesn't populate, nor does the graph or top consumers.
The idea was to see what my total consumption was during the date range and by what breakers.
I was also wondering if it would be possible to permanently set the budget period in the summary to the set range in the billing period that is currently active?
Dashbox current firmware: 4.2.3d3f2
GEM Firmawer:
-COM firmware ver: 4.33
-ENG firmware ver: 1.49
Custom date range on Overview Summary (Dashbox)
-
- Posts: 39
- Joined: Sun May 21, 2017 2:16 am
-
- Site Admin
- Posts: 4266
- Joined: Fri Jun 04, 2010 9:39 am
Re: Custom date range on Overview Summary (Dashbox)
This is fixed in the release we're working towards.
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Brultech Research Inc.
E: ben(at)brultech.com
-
- Posts: 39
- Joined: Sun May 21, 2017 2:16 am
Re: Custom date range on Overview Summary (Dashbox)
Ahh, ok, well I'll wait then
And one last question, is there a mailing list for getting emails when there are firmware updates?
And one last question, is there a mailing list for getting emails when there are firmware updates?
-
- Site Admin
- Posts: 4266
- Joined: Fri Jun 04, 2010 9:39 am
Re: Custom date range on Overview Summary (Dashbox)
Not yet but we'll probably have the DashBox automatically detect new updates when attached to the internet.Visseroth wrote:Ahh, ok, well I'll wait then
And one last question, is there a mailing list for getting emails when there are firmware updates?
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Brultech Research Inc.
E: ben(at)brultech.com
-
- Posts: 39
- Joined: Sun May 21, 2017 2:16 am
Re: Custom date range on Overview Summary (Dashbox)
Oh, that would be good. I also run FreeNAS and it sends email notifications (when email is setup) when updates are available.