4.22 to 4.33 Fimrware Update Failure
Posted: Tue Dec 05, 2017 7:08 pm
I updated firmware 4.22 to 4.33 - the upload seemed to go just fine (it got to 100%) i did it over the dashbox:80001 interface (to stop me running into the updating over ethernet issue)
Now on reboot i get:
"Requesting GEM Serial Number..." and then pops up a box saying "Refresh error 2 0 // Response data = // Data Length = 0" and "FAIL # 2" (the former in a popup window, and the latter in the status window).
I tried pulling the battery, and power, that didn't help.
The only lights lit are the com lights, the sustem lights are out (they come on, but go off when the com light goes on)
Alex
Now on reboot i get:
"Requesting GEM Serial Number..." and then pops up a box saying "Refresh error 2 0 // Response data = // Data Length = 0" and "FAIL # 2" (the former in a popup window, and the latter in the status window).
I tried pulling the battery, and power, that didn't help.
The only lights lit are the com lights, the sustem lights are out (they come on, but go off when the com light goes on)
Alex