Net Alias can't exceed 25 characters error when saving

Ask questions about the GEM here.
ben
Site Admin
Posts: 4254
Joined: Fri Jun 04, 2010 9:39 am

Re: Net Alias can't exceed 25 characters error when saving

Post by ben » Mon Oct 16, 2017 2:47 pm

Teken wrote:For the benefit of others who may stumble upon this thread and need to do the very same. When Ben indicates the CT Type / CT Range needs to be manually adjusted. You will select the channel in question (In Red) then change the CT Type / CT Range values (In red) to the desired numerical values to obtain the most accurate readings.
You also need to switch the green dropdown to Manual in your screenshot.
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Teken
Posts: 2700
Joined: Wed Dec 15, 2010 4:09 pm
Location: The Bad Lands

Re: Net Alias can't exceed 25 characters error when saving

Post by Teken » Mon Oct 16, 2017 2:49 pm

ben wrote:
Teken wrote:For the benefit of others who may stumble upon this thread and need to do the very same. When Ben indicates the CT Type / CT Range needs to be manually adjusted. You will select the channel in question (In Red) then change the CT Type / CT Range values (In red) to the desired numerical values to obtain the most accurate readings.
You also need to switch the green dropdown to Manual in your screenshot.
Doh . . . I highlighted it earlier but must have snapped back to the previous setting. I'll reload it again didn't even notice that! :oops:
Teken . . .

My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10
Teken
Posts: 2700
Joined: Wed Dec 15, 2010 4:09 pm
Location: The Bad Lands

Re: Net Alias can't exceed 25 characters error when saving

Post by Teken » Mon Oct 16, 2017 3:22 pm

For the benefit of others so they don't need to scan hundreds of threads to find this specific information there is a sticky thread on this process: http://www.brultech.com/community/viewt ... =29&t=1812
Teken . . .

My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10
Post Reply