Gem not going into setup mode ???????
Posted: Thu Mar 02, 2017 6:09 pm
Hi,
I purchased the GEM and Dashbox at the end of Feb 2017. I'm yet to get it running however and at wits end. I previously had the ECM 1240 setup so I'm familiar with some of the Burltech setups.
I can see the dashbox as I was able to pick it up off the router. (the network discovery tool did not find it) I can access the dashbox VIA the browser and can get to the setup secreen. but when trying the :8001 port after the IP i'm getting the black triangle with question marks (code translation issue). Despite using different systems and browsers i sill cannot get it to run. I have the STS cable running from COM1 to the Dashbox 1
Can someone please help me, i have tried for hours trying to get it to run, and i'm somewhat at a loss. i have included some photos at http://www.2advancedit.ca/gemdash.html of my installation.
thanks Doug
I purchased the GEM and Dashbox at the end of Feb 2017. I'm yet to get it running however and at wits end. I previously had the ECM 1240 setup so I'm familiar with some of the Burltech setups.
I can see the dashbox as I was able to pick it up off the router. (the network discovery tool did not find it) I can access the dashbox VIA the browser and can get to the setup secreen. but when trying the :8001 port after the IP i'm getting the black triangle with question marks (code translation issue). Despite using different systems and browsers i sill cannot get it to run. I have the STS cable running from COM1 to the Dashbox 1
Can someone please help me, i have tried for hours trying to get it to run, and i'm somewhat at a loss. i have included some photos at http://www.2advancedit.ca/gemdash.html of my installation.
thanks Doug