Can no longer connect to GEM - Ethernet only model
Posted: Wed Dec 07, 2016 10:22 pm
I'm stuck and hoping I'm doing something wrong.
Symptom: Cannot connect to the GEM using Network Utility Ver7.0 even though performing a "Search" on the Ethernet Only tab successfully finds the device. Also cannot connect using a web browser. When using the Network Utility, I get a pop-up dialog box reading "Could not connect!" after clicking the Open button in the Connection area.
Things I've tried:
1) Pinging the GEM. This is successful with response times <1ms.
2) Unplugging the GEM and trying again.
3) Unplugging the GEM, removing the battery, waiting ~1min, and trying again.
4) Trying each of the Baud rates.
5) Normal vs Firmware Mode in Comm Setting
6) Connecting as TCP Server
7) "F1" Push button sequence function
Everything I've tried had the same result "Could not connect!" I searched through the forums here and found connection issue threads, but nothing quite like this and most of them had some level of success trying the things in my list above.
Any ideas? My IP settings are in the SS below.
Thanks in advance.
Symptom: Cannot connect to the GEM using Network Utility Ver7.0 even though performing a "Search" on the Ethernet Only tab successfully finds the device. Also cannot connect using a web browser. When using the Network Utility, I get a pop-up dialog box reading "Could not connect!" after clicking the Open button in the Connection area.
Things I've tried:
1) Pinging the GEM. This is successful with response times <1ms.
2) Unplugging the GEM and trying again.
3) Unplugging the GEM, removing the battery, waiting ~1min, and trying again.
4) Trying each of the Baud rates.
5) Normal vs Firmware Mode in Comm Setting
6) Connecting as TCP Server
7) "F1" Push button sequence function
Everything I've tried had the same result "Could not connect!" I searched through the forums here and found connection issue threads, but nothing quite like this and most of them had some level of success trying the things in my list above.
Any ideas? My IP settings are in the SS below.
Thanks in advance.