GEM showing Sys Status: Err2

Ask questions about the GEM here.
Post Reply
mlater
Posts: 2
Joined: Sat Jan 23, 2016 4:40 pm

GEM showing Sys Status: Err2

Post by mlater » Fri Nov 25, 2016 6:32 pm

I had my GEM offline for a bit as I could not get it to reliably communicate with the standalone dashboard. I gave up on that and recently paid up for a dashbox. But in trying to get that setup I'm running in to issues again. it worked for a day or so but now shows last packet received over a week ago.

I go to the setup page for my GEM and see this.

COM firmware ver: 4.0
ENG firmware ver: 1.49
RealTime Status: ON
Packet Send Interval: 15
Pri. Packet Format: 4
Sec. Packet Format: 4
Sys Status: Err2

How do I resolve the Err2 status and get it working reliably with the dashbox?

Also, just about every other click on the Setup page menus drops me back to the entry screen with only the "Enter Setup Mode" button. What is up with that?
Attachments
GEem Status.JPG
GEem Status.JPG (77.9 KiB) Viewed 1159 times
Teken
Posts: 2700
Joined: Wed Dec 15, 2010 4:09 pm
Location: The Bad Lands

Re: GEM showing Sys Status: Err2

Post by Teken » Fri Nov 25, 2016 7:27 pm

Hello Mlater,

Can you provide a screen capture of the advanced tab in the GEM.

Also did you ever power down the GEM for an extended period of time?

Lastly, can you show me the DB baud rate, system, and the other various tabs in the DB.


=========================

The highest calling in life is to serve ones country faithfully - Teach others what can be. Do what is right and not what is popular.
Teken . . .

My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10
Post Reply