Packets being sent to SEG

[tnakelski]

I was trying to help a person in the SEG forum who was having some trouble with the data that was being sent to SEG. After having him do a couple of things it looks like SEG is OK, the issue looks like the packet that is getting sent from the GEM to SEG. I asked him to post the packet trace from the GEM. It appears that it is only sending the p_ info and the voltage info, no e_ info. See below his packet trace.

In GEM under "Show Packet": (site 9f1cdxxxx3e5dda (node GEM ? (p_1 1)(p_2 0)(p_3 2)(p_4 0)(p_5 1)(p_6 28)(p_7 4)(p_8 7)(p_9 20)(p_10 3)(p_11 5)(p_12 2)(p_13 3)(p_14 127)(p_15 1)(p_16 4)(p_17 143)(p_18 0)(p_19 7)(p_20 0)(p_21 1)(p_22 1)(p_23 4)(p_32 359)(voltage 122.6)))

My assumption is that it always will send a P_ and E_ for each channel that is selected to send. Is my assumption correct? If not, is there a check box that needs to be checked on the GEM? If it is designed to send the P_ and E_ together what would cause the GEM not to send the E_ data?

Below is the link to the SEG forum

https://smartenergygroups.com/forums/14 ... laying-Kwh

Thanks Tony

[Teken]

Will need to see what engine & com firmware he is running along with a few screen shots of his settings. Another API trace taken from the GEM will also need to be captured and posted here.

[tnakelski]

Teken the e_ data should be automatically sent along with the p_ data, correct? Also isn't the a_ data included with the P_ and E_ data usually?
He also states that he is running the current e & c firmware.
I will post in the SEG forum and see if he can post the requested info in the Brultech forum.

Update the issue has been resolve, he set the GEM to "Send Current Values"

[Teken]

Right on good to know.


Ideals are peaceful - History is violent