I just recently setup my GEM and DB and am getting the wrong readings off one of my two CT-200s. One is correct (measured against my fluke clamp meter), other is reading consistently 56.2% low. Both are configured the same in GEM Channels.
Thanks,
Nathan
slit CT 200 giving wrong reading
-
- Posts: 57
- Joined: Mon Apr 20, 2015 3:37 pm
- Location: New Brunswick
-
- Posts: 2700
- Joined: Wed Dec 15, 2010 4:09 pm
- Location: The Bad Lands
Re: slit CT 200 giving wrong reading
Hello Nathan,nbarnard wrote:I just recently setup my GEM and DB and am getting the wrong readings off one of my two CT-200s. One is correct (measured against my fluke clamp meter), other is reading consistently 56.2% low. Both are configured the same in GEM Channels.
Thanks,
Nathan
1. Is the 200 split CT monitoring a 240 circuit?
2. Are each CT's inserted into their (own) GEM channel or wired together?
3. What is the reference load you're measuring?
4. Please post up some of the CT settings in the GEM's advanced tab here for review.
5. If you review the power readings in the GEM's set up page are they correct vs the DB?
Teken . . .
My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10
My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10
-
- Posts: 57
- Joined: Mon Apr 20, 2015 3:37 pm
- Location: New Brunswick
Re: slit CT 200 giving wrong reading
Lol, I had it wired as a type 2 instead of type 1 CT. It works fine now.
-
- Posts: 2700
- Joined: Wed Dec 15, 2010 4:09 pm
- Location: The Bad Lands
Re: slit CT 200 giving wrong reading
Ha . . . Glad its all sorted out!nbarnard wrote:Lol, I had it wired as a type 2 instead of type 1 CT. It works fine now.
Teken . . .
My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10
My ongoing projects thread: http://www.brultech.com/community/viewt ... ?f=2&t=929
Buy me a cup of coffee: https://www.paypal.me/Teken https://gfinotify.com/ Discount Code: PC10