Crestron Module

Post any 3rd party software here.
Post Reply
ayates
Posts: 55
Joined: Thu Nov 25, 2010 11:51 am

Crestron Module

Post by ayates » Fri Jan 28, 2011 2:11 pm

I have created a Crestron module which communicates with the ECM Engine on the PC, returning mostly the instantaneous power consumption of all the loads and a number of other tidbits (threshold based on/off outputs, total house power and unaccounted power, etc). Multiple ECM-1240 units are supported.

Currently the ASCII protocol from the Engine is supported. I am planning on adding support for the binary protocol. This will give access to the watt-second information allowing calculation of the power used in the past 24 hours, etc.

The module can be downloaded from: http://yates.ca/crestron/

If you have any questions or would like to report a bug or suggest enhancements, feel free to contact me.


Allan.
tdinardo
Posts: 2
Joined: Sat Feb 25, 2017 3:21 pm

Re: Crestron Module

Post by tdinardo » Sat Feb 25, 2017 3:29 pm

Hi,

I'm trying to integrate my GEM into the Crestron system in a house I am purchasing. Is your module still available (it appears that Brultech removed the 3rd party section of their site)?

Thanks.

Tom
ben
Site Admin
Posts: 4254
Joined: Fri Jun 04, 2010 9:39 am

Re: Crestron Module

Post by ben » Mon Feb 27, 2017 10:23 am

tdinardo wrote:Hi,

I'm trying to integrate my GEM into the Crestron system in a house I am purchasing. Is your module still available (it appears that Brultech removed the 3rd party section of their site)?

Thanks.

Tom
Tom,

Give these links a try:

http://yates.ca/crestron/
Ben
Brultech Research Inc.
E: ben(at)brultech.com
Post Reply